Philips MX5100VR User manual - Page 41

MX5100VR.qxd 6/04/2004 3:37 PM Page 41 DVD to Videotape Duplication 41 Follow the steps below to copy a DVD to a videotape. This will be possible only if the DVD is not copy protected. Before you begin: ● Put a videotape in the cassette compartment. Make sure the tape's record tab is intact and the tape is long enough to record the DVD. ● Put the DVD you want to copy in the disc tray. ● Press VCR so the red VCR light appears on the front of the System. ● Turn on the TV. 4 TIMER SET STANDBY-ON SETUP/ AUDIO/ PROG BAND SUBTITLE ANGLE REC DISPLAY ZOOM SKIP/ CH TITLE C-RESET CLEAR MODE/SPEED SKIP/ CH RETURN DVD DISC TUNER VCR Point the remote control at the System. Press Number buttons 0, 0, 3. "DISC" will appear on the TV screen in the 1 6 top right corner briefly.The DVD logo will also appear. DISC 5 MENU OK STOP PLAY REW FF PAUSE SLOW 123 VCR/TV 456 SEARCH MODE 789 REPEAT REPEAT +10 0 A-B 2 Press MODE/SPEED until the desired tape speed (SP or SLP) appears briefly in the lower left corner of the TV screen. Details about tape speed are on page 77. 3 Press REC I to start recording. The red RECORD light will appear on the front of the System. SURROUND SOUND VOLUME -+ PHILIPS 3,5 2 5-6 4 1 4 Press DVD. Press PLAY B to play the DVD. 5 To pause the recording, press VCR, then press PAUSE k once. The red RECORD light will flash. To resume recording, press REC I or press PAUSE k again. The red RECORD light will come on again. 6 To stop recording, press VCR, then press STOP C. Helpful Hints • A Timer Recording is not possible during DVD to Videotape duplication. • You cannot select Tuner mode during DVD to videotape duplication. • The recording will not be clear if the DVD has copyright protection.