Pioneer AVIC-X920BT Owner's Manual - Page 149
Checking sensor learning, status and driving status, Customizing preferences - dimensions
UPC - 884938104241
View all Pioneer AVIC-X920BT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 149 highlights
Customizing preferences Chapter 31 Customizing preferences When the gear lever is shifted to "R", the signal switches to "High" or "Low". (One of these is displayed depending on the vehicle.) Checking sensor learning status and driving status p The navigation system can automatically use its sensor memory based on the outer dimensions of the tires. 1 Display the "Navi Settings" screen. = For details, refer to Displaying the "Navi Settings" screen on the previous page. 2 Touch [3D Calibration Status]. The "3D Calibration Status" screen appears. 6 1 2 7 3 4 5 1 Speed Indicates the speed detected by the navigation system. (This indication may be different from the actual speed of your vehicle, so please do not use this instead of the speedometer.) 2 Acceleration or deceleration/Rotational speed Indicates acceleration or deceleration velocity of your vehicle. Also, rotational speed when your vehicle turns to left or right is shown. 3 Distance Indicates driving distance. 4 Speed Pulse Indicates the total number of speed pulses. 5 Learning Status Indicates the current driving mode. 6 Inclination Indicates the degree of slope of the street that you are currently on. 7 Degree of learning Sensor learning situations for distance (Distance), right turn (Right Turn), left turn (Left Turn) and 3D detection (3D) are indicated by the length of bars. p When tires have been changed or chains fitted, turning on the Speed Pulse allows the system to detect the fact that the tire diameter has changed, and automatically replaces the value for calculating distance. p If a separately sold speed pulse generator (ND-PG1) is connected, the distance calculation value cannot be replaced automatically. Clearing status You can delete the learned results stored in [Distance], [Speed Pulse] or [Learning Status]. 1 Touch [Distance] or [Speed Pulse]. The following message appears. 2 Touch [Yes]. Clears the results stored in [Distance] or [Speed Pulse]. 3 Touch [Learning Status]. The following message appears. En 149