ZyXEL UAG4100 User Guide - Page 150
Table 62, Label, Description
View all ZyXEL UAG4100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 150 highlights
Chapter 9 Wireless Table 62 Configuration > Wireless > DCS (continued) LABEL Available channels Channels selected 2.4 GHz Channel Deployment DESCRIPTION This text box lists the channels that are available in the 2.4 GHz band. Select the channels that you want the AP to use, and click the right arrow button to add them. This text box lists the channels that you allow the AP to use. Select any channels that you want to prevent the AP from using it, and click the left arrow button to remove them. This field is available only when you set 2.4 GHz Channel Selection Method to auto. Select Three-Channel Deployment to limit channel switching to channels 1,6, and 11, the three channels that are sufficiently attenuated to have almost no impact on one another. In other words, this allows you to minimize channel interference by limiting channel-hopping to these three "safe" channels. 5 GHz Settings Enable 5 GHz DFS Aware Select Four-Channel Deployment to limit channel switching to four channels. Depending on the country domain, if the only allowable channels are 1-11 then the UAG uses channels 1, 4, 7, 11 in this configuration; otherwise, the UAG uses channels 1, 5, 9, 13 in this configuration. Four channel deployment expands your pool of possible channels while keeping the channel interference to a minimum. Select this if your APs are operating in an area known to have RADAR devices. This allows the device to downgrade its frequency to below 5 GHz in the event a RADAR signal is detected, thus preventing it from interfering with that signal. 5 GHz Channel Selection Method Enabling this forces the AP to select a non-DFS channel. Select auto to have the AP search for available channels automatically in the 5 GHz band. Available channels Channels selected Apply Reset Select manual and specify the channels the AP uses in the 5 GHz band. This text box lists the channels that are available in the 5 GHz band. Select the channels that you want the AP to use, and click the right arrow button to add them. This text box lists the channels that you allow the AP to use. Select any channels that you want to prevent the AP from using it, and click the left arrow button to remove them. Click Apply to save your changes back to the UAG. Click Reset to return the screen to its last-saved settings. UAG Series User's Guide 150