ZyXEL UAG4100 User Guide - Page 297

Chapter 25 Security Policy Figure 209 Configuration > Security Policy > Session Control The following table describes the labels in this screen. Table 132 Configuration > Security Policy > Session Control LABEL General Settings UDP Session Time Out Session Limit Settings Enable Session limit IPv4 Configuration Default Session per Host DESCRIPTION Set how many seconds (from 1 to 300) the UAG will allow a UDP session to remain idle (without UDP traffic) before closing it. Select this check box to control the number of concurrent sessions hosts can have. This table lists the rules for limiting the number of concurrent sessions hosts can have. This field is configurable only when you enable session limit. Use this field to set a common limit to the number of concurrent NAT/security policy sessions each client computer can have. If only a few clients use peer to peer applications, you can raise this number to improve their performance. With heavy peer to peer application use, lower this number to ensure no single client uses too many of the available NAT sessions. Add Edit Remove Activate Inactivate Create rules below to apply other limits for specific users or addresses. Click this to create a new entry. Select an entry and click Add to create a new entry after the selected entry. Double-click an entry or select it and click Edit to open a screen where you can modify the entry's settings. To remove an entry, select it and click Remove. The UAG confirms you want to remove it before doing so. To turn on an entry, select it and click Activate. To turn off an entry, select it and click Inactivate. UAG Series User's Guide 297