Brother International 4200CN Users Manual - English - Page 113
Cleaning the Density Sensor
UPC - 012502607458
View all Brother International 4200CN manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 113 highlights
Cleaning the Density Sensor When the printer's density sensor is dirty, follow the steps below to clean it. 1 On the printer's right side, press the side of the power switch marked O to turn the printer off. 2 Push up button A (1) and fully open the front cover (2). 3 Grip the orange tabs at both ends of the transfer roll and gently lift it out of the printer. Lift the roll carefully to prevent waste toner from spilling out. TROUBLESHOOTING 5 - 24
TROUBLESHOOTING
5 - 24
Cleaning the Density Sensor
When the printer's density sensor is dirty, follow the steps below to clean it.
1
On the printer's right side, press the side of the
power switch marked
O
to turn the printer off.
2
Push up button A (1) and fully open the front cover
(2).
3
Grip the orange tabs at both ends of the transfer roll
and gently lift it out of the printer.
Lift the roll carefully to prevent waste toner from
spilling out.