Canon C50FSi Network Video Recorder VK-64/VK-16 Administrator's Manual - Page 130

Set Motion Detection Recording 2 Record before event - enter a number of seconds for the amount of recording time before the event occurs (up to 30 seconds). If Continuous is also set, Record for before event is not available. Note If Record for before event is set, it will take approximately 10 seconds after event occurrence until its display in the viewer. If the resolution is set to MPEG-4, the frame rate set in the VBC60 becomes enabled. 3 Record after event - enter a number of seconds for the amount of recording time after the event occurs (up to 999 seconds). ● Step 7: Set the External Outputs Click the drop-down menu for the target external device and set On or Not specified. Available external outputs depend on the Camera Server. Note Click OK to save the new settings and close the dialog. Click Cancel to discard the new settings. Even though the before event and after event fields are set to 0 seconds, video will still be recorded while motion is detected. Note Refer to the Chapter 6 for optimizing the Motion Detection operation. Tip 130