Canon C50FSi Network Video Recorder VK-64/VK-16 Administrator's Manual - Page 94

Register Camera Server ● Connect to Camera 1 Enter the Host Name or IP address in Host Name or IP, then enter the port number for the Camera Server in Port. The Host Name or IP should be 255 characters or less (each label, separated by a period, must be 63 characters or less), the IP address must be 15 characters or less (each label, separated by a period, must be 3 characters or less), and the Port must be a figure within the range from 1 to 65535. 2 Enter the user name and password to connect to the Camera Server. Enter the user name in User Name and password in Password. The settings are then saved to the Storage Server. Use the user name and password configured on the Camera Server. If the user name and password are not sure, ask for Note the System Administrator of the Camera Server. Storage servers and VK viewers do not support IPv6. 3 Click Connect. Once the Viewer has connected with the Camera Server, a tab is shown next to the Add Camera Server dialog. You must click Connect before clicking OK to close the dialog (the OK button is disabled until you do so). Note When two or more cameras are used with VB150 (when "Video Input" is set to "Single"), two through four tabs are added. The number of tabs shown for a VB150 does not indicate the physical number of cameras connected, but indicates the number of cameras which have been enabled using the VB150 Camera and Video Settings Page. Please refer to Chapter 3, P. 36 of the VB150 User's Manual for more details. If "Video Input" is set to "Single" for VB150, the camera name displayed as the Camera Server Name is the first camera name in the server's camera name list when "Use Camera" is selected on the Camera and Video Settings Page. Therefore, it is recommended that the Administrator should set the first camera name to be a general name, applicable to the entire Camera Server. If you are using a VB150 with the "Settings Web page URL" other than the default setting "admin", a connection error occurs when you click Connect. Restore the default setting and try again. 94