Compaq ProLiant 8000 ProLiant 8000 Servers Maintenance and Service Guide - Page 137
The Integrated Management Log, Single Bit Errors
View all Compaq ProLiant 8000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 137 highlights
6-10 Compaq ProLiant 8000 Servers Maintenance and Service Guide Table 6-2 POST Error Messages continued Error Code Audible Beeps 163-Time & Date Not Set 2 short 164-Memory Size Error 2 short 172-Configuration None Nonvolatile Memory Invalid 173-Slot ID None Mismatch 174-Configuration/ None Slot Mismatch Device Not Found 175-Configuration/ None Slot Mismatch Device Found 177-Configuration None Not Complete 178-Processor None Configuration Invalid 180-Log Reinitialized None 201-Memory Error None 202-Memory Type Mismatch 2 short 203-Memory None Address Error 207-ECC Corrected None Single Bit Errors in DIMM in Memory Module Socket 207-Invalid Memory None Configuration - Check DIMM Installation Probable Source of Problem Invalid time or date in configuration memory. Configuration memory Incorrect. Nonvolatile configuration corrupted. Recommended Action Run the System Configuration Utility and correct. Run the System Configuration Utility and correct. Run the System Configuration Utility and correct. Board replaced, configuration not updated. EISA or PCI board not found. Run the System Configuration Utility and correct. Run the System Configuration Utility and correct. EISA or PCI board added, configuration not updated. Run the System Configuration Utility and correct. Incomplete system configuration detected. Processor type or step does not match configuration memory. The Integrated Management Log has been reinitialized, probably due to corruption of the log. RAM failure detected. An incompatible memory module is installed in the system. RAM failure. Memory module is malfunctioning. Memory module installed incorrectly. Run the System Configuration Utility and correct. Run the System Configuration Utility and correct. Event message, none needed. Run Compaq Diagnostics. Replace failed assembly as indicated. Compare Compaq part numbers from installed memory modules with the manual. If not listed, the memory modules are incompatible and should be replaced or removed. Run Compaq Diagnostics. Replace failed assembly as indicated. Run Compaq Diagnostics. Replace or remove malfunctioning memory module as indicated. Verify placement of memory modules. continued