Compaq ProLiant 8000 ProLiant 8000 Servers Maintenance and Service Guide - Page 71
Lower Processor Support Structure, Processors, Processor Power Modules, Processor Terminator Boards
View all Compaq ProLiant 8000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 71 highlights
2-54 Compaq ProLiant 8000 Servers Maintenance and Service Guide Lower Processor Support Structure To remove the lower processor support structure: 1. Perform the preparation procedures. See "Preparation Procedures" earlier in this chapter. 2. Remove the right side access panel. See "Right Side Access Panel" earlier in this chapter. 3. Remove the front and rear air baffles. See "Front Air Baffle" and "Rear Air Baffle" earlier in this chapter. 4. Remove the main processor air baffle. See "Main Processor Air Baffle" earlier in this chapter. 5. Remove all processors, Processor Power Modules, and terminator boards. See "Processors, Processor Power Modules, Processor Terminator Boards, Processor Board with Tray" earlier in this chapter. 6. Remove the processor support brace. See "Cache Accelerators" earlier in this chapter. 7. Loosen the two thumbscrews at each end of the lower processor support structure . 8. Move the lower processor support structure forward slightly. Then pull it out from the right side of the chassis . 1 2 Figure 2-47. Removing the lower processor support structure Reverse steps 1 through 8 to replace the lower processor support structure.