Compaq ProLiant 8000 ProLiant 8000 Servers Maintenance and Service Guide - Page 39
Power On/ Standby Switch, To remove the Power On/Standby switch
View all Compaq ProLiant 8000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
2-22 Compaq ProLiant 8000 Servers Maintenance and Service Guide Power On/Standby Switch To remove the Power On/Standby switch: 1. Perform the preparation procedures. See "Preparation Procedures" earlier in this chapter. 2. Remove the top access panel. See "Top Access Panel" earlier in this chapter. 3. Disconnect the Power On/Standby switch connector from the I/O board location shown in Figure 2-16. 4. Remove the power LED from the plastic LED holder on the chassis. Figure 2-16. Disconnecting the Power On/Standby switch connector from the I/O board
2-22
Compaq ProLiant 8000 Servers Maintenance and Service Guide
Power On/Standby Switch
To remove the Power On/Standby switch:
1.
Perform the preparation procedures. See
“
Preparation Procedures
”
earlier in this chapter.
2.
Remove the top access panel. See
“
Top Access Panel
”
earlier in this chapter.
3.
Disconnect the Power On/Standby switch connector from the I/O board location shown in
Figure 2-16.
4.
Remove the power LED from the plastic LED holder on the chassis.
Figure 2-16.
Disconnecting the Power On/Standby switch connector from the I/O board