Compaq ProLiant 8000 ProLiant 8000 Servers Maintenance and Service Guide - Page 48
Redundant Rear Processor Fan
View all Compaq ProLiant 8000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 48 highlights
Removal and Replacement Procedures 2-31 Redundant Rear Processor Fan To remove the redundant rear processor fan: 1. Perform the preparation procedures. See "Preparation Procedures" earlier in this chapter. 2. Remove the hot-plug rear processor fan to gain access to the redundant rear processor fan retaining screws. See "Hot-Plug Rear Processor Fan" earlier in this chapter. 3. Loosen the four T-15 screws one quarter turn using a Torx screwdriver. Then remove the screws by hand. 4. Disconnect the two fan cables from the processor board . 5. Pull the redundant rear processor fan out the rear of the unit . 1 3 2 1 Figure 2-26. Removing the redundant rear processor fan Reverse steps 1 through 5 to replace redundant rear processor fan.
Removal and Replacement Procedures
2-31
Redundant Rear Processor Fan
To remove the redundant rear processor fan:
1.
Perform the preparation procedures. See
“
Preparation Procedures
”
earlier in this chapter.
2.
Remove the hot-plug rear processor fan to gain access to the redundant rear processor fan
retaining screws. See
“
Hot-Plug Rear Processor Fan
”
earlier in this chapter.
3.
Loosen the four T-15 screws
one quarter turn using a Torx screwdriver. Then remove
the screws by hand.
4.
Disconnect the two fan cables from the processor board
.
5.
Pull the redundant rear processor fan out the rear of the unit
.
1
1
2
3
Figure 2-26.
Removing the redundant rear processor fan
Reverse steps 1 through 5 to replace redundant rear processor fan.