Compaq ProLiant 8000 ProLiant 8000 Servers Maintenance and Service Guide - Page 37
To remove a hot-plug SCSI hard drive, Press the release button for the SCSI hard drive ejector lever
View all Compaq ProLiant 8000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
2-20 Compaq ProLiant 8000 Servers Maintenance and Service Guide CAUTION: Do not turn off an attached disk drive enclosure when the server containing the Smart Array Controller is powered on. Also, do not turn on the server before turning on the disk enclosure. If these ordering rules are not followed, the Smart Array Controller may mark the drives in this enclosure as "failed," which could result in permanent data loss. NOTE: For more information on hard drive LED statuses refer to chapter 4. To remove a hot-plug SCSI hard drive: CAUTION: Replace a hot-plug SCSI hard drive only when the drive LED is amber. Do not remove a hot-plug SCSI hard drive if the online LED is green. 1. Press the release button for the SCSI hard drive ejector lever . 2. Pull the locking release lever forward. 3. Pull the hard drive from the drive cage . 1 3 2 Figure 2-14. Removing a hot-plug SCSI hard drive Reverse steps 1 through 3 to replace a hot-plug SCSI hard drive.