Compaq ProLiant 8000 ProLiant 8000 Servers Maintenance and Service Guide - Page 69

2-52 Compaq ProLiant 8000 Servers Maintenance and Service Guide To install a Processor Power Module: CAUTION: The redundant Processor Power Module must be installed before the processor. Attempting to install the Processor Power Module after installing the processor could damage the electronic components on the Processor Power Module. 1. Line up the Processor Power Module with the guides in the processor cage at the appropriate processor board slot . 2. Open the Processor Power Module ejector levers to 90 degree angles. Then fully seat the Processor Power Module into its processor board slot. CAUTION: Do not push the Processor Power Module into place by pushing on the ejector levers. 3. Push the Processor Power Module onto the processor board until the levers lower to a flat position . NOTE: An audible click should occur, indicating that the Processor Power Module is fully seated. 2 1 2 Figure 2-45. Replacing a Processor Power Module NOTE: The Processor Power Module is keyed for correct alignment.