Compaq ProLiant 8000 ProLiant 8000 Servers Maintenance and Service Guide - Page 157
Run Compaq Diagnostics and, Controller or Disk
View all Compaq ProLiant 8000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 157 highlights
6-30 Compaq ProLiant 8000 Servers Maintenance and Service Guide Table 6-2 POST Error Messages continued Error Code Audible Beeps 1789-Slot X Drive None Array SCSI Drive(s) Not Responding. Check cables or replace the following SCSI drives: SCSI Port Y: SCSI ID Z Select F1 to continue - drive array will remain disabled. Select F2 to failed drives that are not responding - Interim Recovery Mode will be enabled if configured for fault tolerance. 1790-Disk 0 None Configuration Error 1791-Disk 1 Error None 1792-Drive Array None Reports Valid Data Found in Array Accelerator. Data will automatically be written to drive array. 1792-Secondary None Disk Controller Failure 1793-Secondary None Controller or Disk Failure 1793-Drive Array - None Array Accelerator Battery Depleted - Data Lost (Error message 1794 also displays.) Probable Source of Problem Cable or hard drive failure occurred. Recommended Action 1. Check the cable connections. 2. If cables are connected, replace the drive. 3. If you do not want to replace the drives at this time, press F2. Hard drive error or wrong drive type detected. Hard drive error or wrong drive type detected. This indicates that while the system was in use, power was interrupted while data was in the array accelerator memory. Power was then restored within 8 to 10 days, and the data in the array accelerator was flushed to the drive array. Part of the IDE drive electronics has failed. The IDE controller or an attached drive has failed. This indicates that while the system was in use, power was interrupted while data was in the array accelerator memory. Array accelerator batteries failed. Data in array accelerator has been lost. Run the System Configuration Utility and Diagnostics and Compaq Diagnostics and correct. Replace failed assembly as indicated. Run the System Configuration Utility and Diagnostics and Compaq Diagnostics and correct. Replace failed assembly as indicated. No action necessary; no data has been lost. Perform orderly system shutdowns to avoid data remaining in the array accelerator. Run Compaq Diagnostics and replace failed assembly as indicated. Run Compaq Diagnostics and replace failed assembly as indicated. Power was not restored within 8 to 10 days. Perform orderly system shutdowns to avoid data remaining in the array accelerator. continued