Compaq ProLiant 8000 ProLiant 8000 Servers Maintenance and Service Guide - Page 68
To remove a Processor Power Module, to and
View all Compaq ProLiant 8000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 68 highlights
Removal and Replacement Procedures 2-51 To remove a Processor Power Module: 1. Perform the preparation procedures. See "Preparation Procedures" earlier in this chapter. 2. Remove the right side access panel. See "Right Side Access Panel" earlier in this chapter. 3. Remove the main processor air baffle. See "Main Processor Air Baffle" earlier in this chapter. 4. Remove the processor associated with the Processor Power Module being replaced. Refer to Figure 2-39 and the "Processor" section earlier in this chapter. 5. Rotate the side ejector levers on the module outward . Then slide the module out the right side of the server . 1 2 1 Figure 2-44. Removing a Processor Power Module
Removal and Replacement Procedures
2-51
To remove a Processor Power Module:
1.
Perform the preparation procedures. See
“
Preparation Procedures
”
earlier in this chapter.
2.
Remove the right side access panel. See
“
Right Side Access Panel
”
earlier in this chapter.
3.
Remove the main processor air baffle. See
“
Main Processor Air Baffle
”
earlier in
this chapter.
4.
Remove the processor associated with the Processor Power Module being replaced. Refer
to Figure 2-39 and the
“
Processor
”
section earlier in this chapter.
5.
Rotate the side ejector levers on the module outward
. Then slide the module out the
right side of the server
.
1
1
2
Figure 2-44.
Removing a Processor Power Module