Compaq ProLiant 8000 ProLiant 8000 Servers Maintenance and Service Guide - Page 40
on the Power On/Standby switch assembly. Then push it, from behind the unit out the front
View all Compaq ProLiant 8000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
Removal and Replacement Procedures 2-23 5. If the plastic switch cover is installed, remove it by prying outward on the upper or lower catch with a 4-mm flatblade screwdriver. Then pull it off the switch . 1 2 Figure 2-17. Removing the plastic switch cover 6. Press in on the release tabs on the Power On/Standby switch assembly. Then push it from behind the unit out the front . 3 4 3 Figure 2-18. Removing the Power On/Standby switch and LED Reverse steps 1 through 6 to replace the Power On/Standby switch and LED.
Removal and Replacement Procedures
2-23
5.
If the plastic switch cover is installed, remove it by prying outward on the upper or lower
catch
with a 4-mm flatblade screwdriver. Then pull it off the switch
.
1
2
Figure 2-17.
Removing the plastic switch cover
6.
Press in on the release tabs
on the Power On/Standby switch assembly. Then push it
from behind the unit out the front
.
3
4
3
Figure 2-18.
Removing the Power On/Standby switch and LED
Reverse steps 1 through 6 to replace the Power On/Standby switch and LED.