Compaq ProLiant 8000 ProLiant 8000 Servers Maintenance and Service Guide - Page 73
Processor Board with Tray
View all Compaq ProLiant 8000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 73 highlights
2-56 Compaq ProLiant 8000 Servers Maintenance and Service Guide Processor Board with Tray To remove the processor board with tray: 1. Perform the preparation procedures. See "Preparation Procedures" earlier in this chapter. 2. Remove the top access panel. See "Top Access Panel" earlier in this chapter. 3. Remove the right side access panel. See "Right Side Access Panel" earlier in this chapter. 4. Remove the memory expansion board. See "Memory Expansion Board" earlier in this chapter. 5. Remove the main processor air baffle. See "Main Processor Air Baffle" earlier in this chapter. 6. Remove all Processor Power Modules except the processor board Processor Power Module (ninth VRM), processors, and terminator boards. See "Processors, Processor Power Modules, Processor Terminator Boards, Processor Board with Tray" earlier in this chapter. 7. Remove the front and rear air baffles. See "Front Air Baffle" and "Rear Air Baffle" earlier in this chapter. 8. Loosen the two thumbscrews . Then lift out the processor support brace . 2 1 Figure 2-49. Removing the processor support brace 9. Remove the lower processor support structure. See "Lower Processor Support Structure" earlier in this chapter. 10. Remove the Processor Board Processor Power Module (ninth VRM). See "Processor Power Modules" earlier in this chapter.