Dell 5110cn User Guide - Page 158
IP Filter IPv4, Reset LAN
UPC - 054343272297
View all Dell 5110cn manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 158 highlights
Auto* Automatically sets the frame type. Ethernet II Uses the Ethernet II frame type. Uses the IEEE802.3 frame type. Ethernet 802.3 Uses the IEEE802.2 frame type. Ethernet 802.2 Use the SNAP frame type. Ethernet SNAP NOTE: The IPX/SPX menu is only displayed when an optional multi protocol card is installed on the printer. IP Filter (IPv4) Purpose: To specify the reception of data from certain IP addresses for blocking. You can set up to five IP addresses. The change becomes effective after the printer is turned off and then on again. Values: No.n Address (n is 1 to 5.) Mask Sets the IP address for Filter n. Sets the mask for Filter n. Disable the IP Filter feature for Filter n. Mode Off* Accepts an access from specified IP address. Accept Rejects an access from specified IP address. Reject NOTE: This item is only available for LPD or Port9100. Reset LAN Purpose: To initialize network data stored in NVRAM.