Dell 5110cn User Guide - Page 71

Installing the Optional Tray Module and Cards Precautions Installing the Optional 500-Sheet Tray Module Installing the Optional 1000-Sheet Tray Module Installing the Optional 500-Sheet Tray Module and 1000-Sheet Tray Module Installing a Memory Card Installing a Multi Protocol Card Installing the Dell Wireless Printer Adapter 3310 USB Installing the Hard Disk Precautions NOTE: If you are adding an optional 500-sheet tray module or 1000-sheet tray module after setting up the printer, be sure to turn off the printer, unplug the power cable, and disconnect all cables from the back of the printer before completing these tasks. CAUTION: To lift the optional 1000-sheet tray module safely requires two people. NOTICE: Place the imaging drum on a clean flat surface. Also, cover the imaging drum with something like newspaper to keep it out of direct light. Only one optional 500-sheet tray module and one optional 1000-sheet tray module can be installed under the printer. Some instructions may vary depending on the tray module configuration in your printer. NOTE: Some tray module configurations differ from those described in this manual. Installing the Optional 500-Sheet Tray Module 1. Make sure that the printer is turned off and unplug all cables including the power cord from the rear of the printer. 2. Lift the printer and align the four guide pins of the 500-sheet tray module with the holes at the bottom of the printer. Gently lower the printer onto the optional 500-sheet tray module.