Dell Optiplex-620 User Guide - Page 72
General Installation Guidelines
View all Dell Optiplex-620 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 72 highlights
Back to Contents Page Dell™ OptiPlex™ GX620 User's Guide Drives Drives Your computer supports: l Two serial ATA hard drives l Two floppy or optional Zip drives l Two CD or DVD drives NOTE: Due to the limited number of drive bays and IDE controllers on this computer, you will not be able to connect all supported devices at once. 1 CD/DVD drive 2 floppy drive 3 hard drive General Installation Guidelines Connect CD/DVD drives to the connector labeled "IDE" on the system board. Serial ATA hard drives should be connected to the connectors labeled "SATA0," SATA1," "SATA2," or "SATA3" on the system board. IDE Drive Addressing When you connect two IDE devices to a single IDE interface cable and configure them for the cable select setting, the device attached to the last connector on the interface cable is the master or boot device (drive 0), and the device attached to the middle connector on the interface cable is the slave device (drive 1). See the drive documentation in your upgrade kit for information on configuring devices for the cable select setting. Connecting Drive Cables When you install a drive, you connect two cables-a DC power cable and a data cable-to the back of the drive and to the system board. Drive Interface Connectors IDE Drive Connector Serial ATA Connector