Dell PowerEdge C6105 Hardware Owner's Manual - Page 117
Removing and Installing the 2.5-inch Hard-Drive, Backplane
View all Dell PowerEdge C6105 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 117 highlights
CAUTION: To prevent damage to the drives and backplane, you must remove the hard drives from the system before removing the backplane. CAUTION: You must note the number of each hard drive and temporarily label them before removal so that you can replace them in the same locations. 4 Remove the screws that secure the hard-drive cage to the chassis. See Figure 3-32. Figure 3-32. Removing and Installing the 2.5-inch Hard-Drive Backplane 1 hard-drive cage 2 screw (10) 5 Remove the screws that secure the front-panel assemblies to the chassis. See Figure 3-32. 6 Disconnect all the cables from the backplane. See Figure 5-6 for 2.5inch hard drives. Note the routing of the cable underneath the tabs on the chassis as you remove them from the system. You must route these cables properly when you replace them to prevent the cables from being pinched or crimped. Installing System Components | 117