Dell PowerEdge C6105 Hardware Owner's Manual - Page 125
Sensor Boards, Removing the Sensor Board for 3.5” HDD System
View all Dell PowerEdge C6105 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 125 highlights
5 Replace the screws that secure the front-panel assemblies to the chassis. See Figure 3-30. 6 Replace the screws that secure the hard-drive cage to the chassis. See Figure 3-29. 7 Connect front panel cables to the fan controller board. See Figure 5-11. You must route these cables properly through the tabs on the chassis to prevent them from being pinched or crimped. 8 Connect all the cables to the backplane. See Figure 5-3 for 3.5-inch hard drives and Figure 5-6 for 2.5-inch hard drives. You must route these cables properly through the tabs on the chassis to prevent them from being pinched or crimped. 9 Close the system. See "Closing the System" on page 98. 10 Replace the hard drives. See "Installing a Hard Drive into a Hard-Drive Carrier" on page 64. 11 Reconnect the system to its electrical outlet and turn on the system, including any attached peripherals. Sensor Boards Removing the Sensor Board for 3.5" HDD System CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product. 1 Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet. 2 Remove all the hard drives. See "Removing a Hard-Drive Carrier" on page 61. 3 Open the system. See "Opening the System" on page 97. Installing System Components | 125