Dell PowerEdge R540 EMC Installation and Service Manual - Page 109
Expansion cards and expansion card risers, Expansion card installation guidelines
View all Dell PowerEdge R540 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 109 highlights
b. Tighten the second screw completely. c. Return to the first screw and tighten it completely. If the PHM slips off the blue retention clips when the screws are partially tightened, follow these steps to secure the PHM: a. Loosen both the heat sink screws completely. b. Lower the PHM on to the blue retention clips, following the procedure described in step 2. c. Secure the PHM to the system board, following the replacement instructions listed in this step above. 4. Figure 64. Installing the processor and heat sink module Next steps 1. Install the air shroud. 2. Follow the procedure listed in After working inside your system on page 67. Expansion cards and expansion card risers Expansion card installation guidelines The following table describes the supported expansion cards: Table 47. Expansion card riser configurations Expansion card riser PCIe slots on the riser Full height right riser Slot 2 Processor connection Processor 1 Height Full Height Low profile right riser Slot 2 Processor 1 Low Profile Low profile left riser Slot 3 Processor 2 Low Profile Butterfly riser Slot 2 Processor 1 Full Height Butterfly riser Slot 3 Processor 1 Low Profile Length Half Length Half Length Half Length Half Length Half Length Slot width x16 x16 x16 x16 x8 Installing and removing system components 109