Dell PowerEdge R540 EMC Installation and Service Manual - Page 130
Optional MicroSD or vFlash card, Removing the MicroSD card
![]() |
View all Dell PowerEdge R540 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 130 highlights
Figure 90. Installing the M.2 SSD module Next steps 1. Install the BOSS card. NOTE: The procedure to install the BOSS card is similar to the Installing expansion card on the system board on page 121. 2. Install the applicable air shroud. 3. Follow the procedure listed in After working inside your system. Optional MicroSD or vFlash card Removing the MicroSD card Prerequisites 1. Follow the safety guidelines listed in Safety instructions on page 66. 2. Follow the procedure listed in Before working inside your system on page 67. Steps 1. Locate the MicroSD card slot on the vFlash/IDSDM module, and press the card to partially release it from the slot. To locate IDSDM/ vFlash module, see the System board jumpers and connectors section. 2. Hold the MicroSD card and remove it from the slot. 130 Installing and removing system components
![](/manual_guide/products/dell-poweredge-r540-emc-installation-service-manual-665d651/130.png)