Dell PowerEdge R540 EMC Installation and Service Manual - Page 90
Installing a drive blank, Removing a 2.5-inch drive from a 3.5-inch drive adapter
View all Dell PowerEdge R540 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 90 highlights
Figure 45. Removing a drive blank Next steps 1. Installing a drive blank on page 90 Installing a drive blank The procedure for installing 2.5-inch and 3.5-inch drive blanks is identical. Prerequisites 1. Follow the safety guidelines listed in Safety instructions on page 66. 2. If installed, Removing the front bezel on page 68 CAUTION: Mixing drive blanks from previous generations of PowerEdge servers is not supported. Steps Insert the drive blank into the drive slot, and push the blank until the release button clicks into place. Figure 46. Installing a drive blank Next steps If removed, Installing the front bezel on page 68 Removing a 2.5-inch drive from a 3.5-inch drive adapter Prerequisites 1. Follow the safety guidelines listed in Safety instructions on page 66. 2. Removing a 3.5-inch drive adapter from a 3.5-inch drive carrier on page 92 90 Installing and removing system components