Dell PowerEdge R540 EMC Installation and Service Manual - Page 164
Installing the system board
![]() |
View all Dell PowerEdge R540 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 164 highlights
Figure 127. Removing the system board Next steps Installing the system board on page 164. Installing the system board Prerequisites Follow the safety guidelines listed in Safety instructions on page 66. Steps 1. Unpack the new system board assembly. CAUTION: Do not lift the system board by holding a memory module, processor, or other components. CAUTION: Take care not to damage the system identification button while placing the system board into the chassis. 2. Holding the system board holder, push the system board toward the back of the system until it is seated. 3. Using Phillips #2 screwdriver, tighten the screws to secure the system board to the chassis. 164 Installing and removing system components
![](/manual_guide/products/dell-poweredge-r540-emc-installation-service-manual-665d651/164.png)
Figure 127. Removing the system board
Next steps
Installing the system board
on page 164.
Installing the system board
Prerequisites
Follow the safety guidelines listed in
Safety instructions
on page 66.
Steps
1.
Unpack the new system board assembly.
CAUTION:
Do not lift the system board by holding a memory module, processor, or other components.
CAUTION:
Take care not to damage the system identification button while placing the system board into the chassis.
2.
Holding the system board holder, push the system board toward the back of the system until it is seated.
3.
Using Phillips #2 screwdriver, tighten the screws to secure the system board to the chassis.
164
Installing and removing system components