Dell PowerEdge R540 EMC Installation and Service Manual - Page 161
Installing the right control panel
![]() |
View all Dell PowerEdge R540 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 161 highlights
Figure 124. Removing right control panel 3. Holding by the sides, remove the right control panel assembly away from the system. Next steps Installing the right control panel on page 161 Installing the right control panel Prerequisites Follow the safety guidelines listed in Safety instructions on page 66. Steps 1. Route the control panel cable through the side wall of the system. 2. Align the right control panel assembly with the control panel slot on the system and attach the control panel assembly to the system. 3. Connect the control panel cable to the connector on the system board and lower the cable latch to secure the cable in place. 4. Using a Phillips #1 screwdriver, tighten the screws to secure the right control panel assembly to the system. Installing and removing system components 161
![](/manual_guide/products/dell-poweredge-r540-emc-installation-service-manual-665d651/161.png)