Dell PowerEdge R640 EMC PowerEdge R640 Installation and Service Manual - Page 52
SATA Settings, Viewing SATA Settings
![]() |
View all Dell PowerEdge R640 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 52 highlights
Option Description Intel SST-CP Enable Intel SST-CP. This option is displayed if Performance Per Watt (operating system) or Custom (when OSPM is enabled) system profiles are selected. It is set to Disabled by default. Configurable TDP Enables you to configure the TDP level. The available options are Nominal, Level 1, and Level 2. This option is set to Nominal by default. NOTE: This option is only available on certain stock keeping units (SKUs) of the processors. SST-Performance Enables you to reconfigure the processor using Speed Select Technology. Profile x2APIC Mode Enables or disables the x2APIC mode. This option is set to Enabled by default. Dell Controlled Turbo Controls the turbo engagement. Enable this option only when System Profile is set to Disabled. NOTE: Depending on the number of installed processors, there might be up to fourtwo processor listings. Dell AVX Scaling Technology Number of Cores per Processor Processor Core Speed Processor Bus Speed Processor n Enables you to configure the Dell AVX scaling technology. This option is set to 0 by default. Controls the number of enabled cores in each processor. This option is set to All by default. Specifies the maximum core frequency of the processor. Displays the bus speed of the processor. NOTE: Depending on the number of processors, there might be up to fourtwo processors listed. The following settings are displayed for each processor that is installed in the system: Option Description Family-ModelStepping Specifies the family, model, and stepping of the processor as defined by Intel. Brand Specifies the brand name. Level 2 Cache Specifies the total L2 cache. Level 3 Cache Specifies the total L3 cache. Number of Cores Specifies the number of cores per processor. Maximum Memory Specifies the maximum memory capacity per processor. Capacity Microcode Specifies the microcode. SATA Settings You can use the SATA Settings screen to view the settings of SATA devices and enable SATA and PCIe NVMe RAID mode on your system. Viewing SATA Settings To view the SATA Settings screen, perform the following steps: Steps 1. Power on, or restart your system. 2. Press F2 immediately after you see the following message: F2 = System Setup 52 Pre-operating system management applications
![](/manual_guide/products/dell-poweredge-r640-emc-poweredge-r640-installation-service-manual-aa74b7c/52.png)