Dell PowerEdge R640 EMC PowerEdge R640 Installation and Service Manual - Page 76
Drives, Removing a drive blank
View all Dell PowerEdge R640 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 76 highlights
Figure 23. Installing the system cover Next steps 1. Reconnect the peripherals and connect the system to the electrical outlet. 2. Turn on the system, including any attached peripherals. Drives Removing a drive blank The procedure for removing 2.5 inch and 3.5 inch drive blanks is identical. Prerequisites 1. Follow the safety guidelines listed in Safety instructions on page 71. 2. If installed, remove the front bezel. CAUTION: To maintain proper system cooling, drive blanks must be installed in all empty drive slots. CAUTION: Mixing drive blanks from previous generations of PowerEdge servers is not supported. Steps Press the release button, and slide the drive blank out of the drive slot. 76 Installing and removing system components
Figure 23. Installing the system cover
Next steps
1.
Reconnect the peripherals and connect the system to the electrical outlet.
2.
Turn on the system, including any attached peripherals.
Drives
Removing a drive blank
The procedure for removing 2.5 inch and 3.5 inch drive blanks is identical.
Prerequisites
1.
Follow the safety guidelines listed in
Safety instructions
on page 71.
2.
If installed,
remove the front bezel.
CAUTION:
To maintain proper system cooling, drive blanks must be installed in all empty drive slots.
CAUTION:
Mixing drive blanks from previous generations of PowerEdge servers is not supported.
Steps
Press the release button, and slide the drive blank out of the drive slot.
76
Installing and removing system components