Dell PowerEdge T110 Hardware Owner's Manual - Page 27
Quad rank DIMM, SATA Port x - second drive installation
View all Dell PowerEdge T110 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
Message Causes Corrective Actions Plug & Play Configuration Error. Error encountered in initializing PCIe device; faulty system board. Install the NVRAM_CLR jumper in the clear position (pins 1 and 3) and reboot the system. See Figure 6-1 for jumper location. If the problem persists, see "Troubleshooting Expansion Cards" on page 118. Quad rank DIMM detected after single rank or dual rank DIMM in socket. Invalid memory configuration. Ensure that the memory modules are installed in a valid configuration. See "General Memory Module Installation Guidelines" on page 80. Read fault. Requested sector not found. The operating system Replace the optical medium, cannot read from the hard USB medium or device. drive, optical drive, or USB Ensure that the USB or SATA device; the system could cables are properly connected. not find a particular sector See "Troubleshooting a USB on the disk, or the Device" on page 106, requested sector is "Troubleshooting an Optical defective. Drive" on page 115, and "Troubleshooting a Hard Drive" on page 117 for the appropriate drive(s) installed in your system. SATA Port x There is no device Information only. device not found. connected to the specified SATA port. SATA port x device autosensing error. The drive connected to the Replace the faulty drive. specified SATA port is faulty. SATA port x device configuration error. SATA port x device error. About Your System 27