Dell PowerEdge T110 Hardware Owner's Manual - Page 94
Installing the Power Supply, Secure the I/O panel and SATA cables if present to the routing clip
View all Dell PowerEdge T110 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 94 highlights
Figure 3-19. Removing the Power Supply 2 1 4 1 power supply 3 cable clip 3 2 screws (4) 4 power-supply release tab Installing the Power Supply 1 Attach the cable clip to the new power supply. 2 Align the power supply mounting holes with the mounting holes on the back panel. 3 Slide the power supply toward the back panel until it snaps into place over the power-supply release tab. 4 Using a #2 Phillips screwdriver, install the four screws that secure the power supply to the back panel. 5 Secure the I/O panel and SATA cables (if present) to the routing clip on the side of the power supply. 6 Connect all the power cables to the system board and drives. 7 Replace the cooling shroud. See "Installing the Cooling Shroud" on page 74. 94 Installing System Components