Dell PowerEdge T110 Hardware Owner's Manual - Page 71
Removing a Hard Drive from a Hard-Drive Bracket, Exit the System Setup program and reboot the system.
View all Dell PowerEdge T110 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 71 highlights
Figure 3-10. Attaching a SAS Hard Drive to a SAS Controller Expansion Card 3 2 4 1 1 SAS hard drive 3 data cable to SAS controller card 2 power/data cable to hard drive 4 SAS controller card 7 Replace the system cover. See "Closing the System" on page 58. 8 Place the system upright on a flat, stable surface. 9 Reattach any peripherals and connect the system to an electrical outlet. 10 Turn on the system and attached peripherals. 11 Enter the System Setup program and ensure that the hard drive's controller is enabled. See"Entering the System Setup Program" on page 36. 12 Exit the System Setup program and reboot the system. 13 Partition and logically format the drive. See the documentation that came with the drive for instructions on installing any software required for drive operation. Removing a Hard Drive from a Hard-Drive Bracket Detach the hard-drive bracket from the hard drive by pushing out at the edges of the bracket and removing the hard drive. See Figure 3-11. Installing System Components 71