GE 60-806-95R-16Z Installation Instructions - Page 13
Installing Optional SnapCards, Installing Optional Hardwire Input Modules HIMs - concord express
UPC - 046188090938
View all GE 60-806-95R-16Z manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Note For best results, it is recommended that you crimp a spade lug on the wire end at the panel and secure the lug under the circuit board screw as shown in Figure . Antenna Loop Pipe Water Pipe Ground Clamp Knockout Figure 5. Connecting the Panel to Earth Ground Installing Optional SnapCards The SnapCard Header on the lower-left side of the panel accepts one of the following SnapCard models: • 8Z Input SnapCard-60-757 • 4 Output SnapCard-60-758 • 4Z Input/2 Output Combo SnapCard-60-756 Install the desired SnapCard onto the panel SnapCard Header and secure it in place with two screws, included with the card (Figure 6). Connect all necessary input/output wiring using the installation instructions included with the SnapCard. Note Use of the HIM with the Concord™ Express panel has not been investigated by UL. Push SnapCard Connector Onto Panel Header Secure SnapCard with Two Screws Figure 6. Installing a SnapCard Installing Optional Hardwire Input Modules (HIMs) Each SuperBus 2000 8-Zone Input Module (60-774) adds eight supervised hardwire zones to the system. Both normally open and normally closed detectors can be wired to module inputs (see Figure 8). Connect all necessary input/output wiring using the installation instructions included with the HIM. Installing the System 8