GE 60-806-95R-16Z Installation Instructions - Page 34

Remote Access (0210) Phones Options-Partition 1 (Default=on) This setting determines whether or not the panel can be accessed from off-site for downloader programming. ¾ To turn Remote Access off or on: 1. With the display showing REMOTE ACCESS OFF/ON (current setting), press 1 (off) or 2 (on). The display flashes the entered setting. 2. Press ƒ and the display shows the new setting. Ring/Hang/Ring (0211) This setting determines how the panel picks up (seizes) the phone line for downloader programming by remote access. Note The Remote Access setting (0210) must be turned on for this feature to work. When this feature is on, the caller must listen for one or two full rings, hang up, then call the premises again within the next 10-40 seconds. The system then answers after the first ring. The "on" setting is recommended if an answering machine shares the phone line with the panel. When Ring/Hang/Ring is turned off, the caller must listen for 12 full rings before the system answers. The "off" setting is recommended if there is no answering machine sharing the phone line with the panel. Phones Options-Partition 1 (Default=on) ¾ To turn Ring/Hang/Ring access off or on: 1. With the display showing RING/HANG/RING OFF/ON (current setting), press 1 (off) or 2 (on). The display begins flashing the entered selection. 2. Press ƒ and the display shows the new setting. Timers Menu The TIMERS menu lets you set up the various system feature times that affect the whole system (global) or a specific partition. The following describes how to program the timer settings that appear under GLOBAL. Supervisory Time (0300) Timers-Global (Default=random) This setting determines what time of day the panel sends supervisory, low bat- ¾ To set the Supervisory Time: tery, or auto phone test reports to the central station. The setting is based on a 1. With the display showing SUPERVISORY TIME 24-hour timer so there is no need to enter A.M. and P.M. settings. These will HH:MM (current setting), enter the desired 4- appear automatically on the display. digit time value (for example, enter 1330 to Note The panel clock must be set with the correct time for accurate supervisory time reporting. Refer to the user programming section for setting the panel clock. set the supervisory time for 1:30 p.m.). The display flashes the entered setting. 2. Press ƒ and the display shows the new set- ting. RF Tx Timeout (0301) Timers-Global (Default=12 hours) If any supervised wireless device stops sending supervisory transmissions, the ¾ To set the RF Tx Timeout: panel reports a supervisory condition to the central station. This setting deter- 1. With the display showing RF TX TIMEOUT nn mines how long the panel should wait (2-24 hours) for a supervisory transmis- HOURS (current setting), enter the desired sion before sending the report. 2-digit timeout value (02-24). The display Note For UL 985 & 1635 listed installations, the RF Tx Timeout must be set to 4 hours. For UL 1023 listed installations, the RF Tx Timeout must be set to 24 hours. flashes the entered setting. 2. Press ƒ and the display shows the new setting. 29 Programming the Panel