GE 60-806-95R-16Z Installation Instructions - Page 33

Dialer Abort (02005) Phones Options-Global (Default=on) This setting determines whether or not users can stop the first dialing attempt of the panel (within the Dialer Abort Delay time setting) to report to the central station. When this feature is on, alarm reports from sensors in groups 0020, 34, and 35 can be aborted by entering CODE (or 1 + CODE) within the Dialer Abort Delay time setting (defaulted to 30 seconds). Cancel and restoral reports from these sensor groups are also aborted if the related alarm report was aborted. Other reports that can be aborted include System Alarm Tamper/Cancel, No Activity Alarm/Cancel, Touchpad Police and Auxiliary Panic/Cancel, Recent Closing, and Two Trip Error. Fire alarm reports to the central station cannot be aborted. ¾ To turn Dialer Abort off or on: 1. With the display showing DIALER ABORT OFF/ON (current setting), press 1 (off) or 2 (on). The display flashes the entered setting. 2. Press ƒ and the display shows the new setting. Dialer Abort Delay (02006) This setting determines how much time (15 to 45 seconds) the user has to enter the disarm command in order to prevent the panel from reporting to the central monitoring station. Note For UL Listed systems, the combined time for the Entry Delay (0310) and Dialer Abort Delay must not exceed 60 seconds. Phones Options-Global (Default=30 sec.) ¾ To change the Dial Abort Delay: 1. With the display showing DIAL ABORT DELAY nn (current setting), enter the desired time (15 to 45 seconds). The display flashes the entered setting. 2. Press ƒ and the display shows the new setting. Cancel Message (02007) This setting determines whether or not the panel displays a cancel message after the user disarms the system to clear an alarm condition. Phones Options-Global (Default=on) ¾ To turn Cancel Message off or on: 1. With the display showing CANCEL MESSAGE OFF/ON (current setting), press 1 (off) or 2 (on). The display flashes the entered setting. 2. Press ƒ and the display shows the new setting. Pager Delay (02008) Phones Options-Global (Default=15 sec.) This setting determines how long a report is delayed to a pager (00-30 seconds) after the panel dials the pager number. Note The Pager Delay time should not be set below 5 seconds unless absolutely necessary. ¾ To set the Pager Delay time: 1. With the display showing PAGER DELAY nn (current setting), enter a two-digit time (0030). The display flashes the entered setting. 2. Press ƒ and the display shows the new setting. Call Wait Cancel (02009) Phones Options-Global (Default=none) This feature lets you set up a dialing prefix to disable the call waiting feature before the panel makes its first dialing attempt to any programmed central monitoring station, pager, or downloader phone number. The prefix can be up to eight digits. For prefixes that require dialing * or #, press and hold for two seconds 7 (for *) or 9 (for #). ¾ To set up Call Wait Cancel: 1. With the display showing CALL WAIT CANCEL __ (or current setting), enter the desired prefix. The display flashes the entered setting. 2. Press ƒ and the display shows the new setting. ! Caution DO NOT change this option from its default if the customer doesn't have call waiting. Verify with the customer that they have call waiting with their phone service provider before changing this option from its default. Changing this option from its default without call waiting will prohibit the panel from calling the central station. The following describes how to program the PHONE OPTION settings that appear under PARTITION 1. Programming the Panel 28