GE 60-806-95R-16Z Installation Instructions - Page 27

Quick Exit (0012) Security-Partition 1 (Default = on) This setting determines whether or not users can open and close a standard entry or exit door without causing an alarm (while the system is armed). This feature would be useful if the user wanted to go out to get the morning paper while the system was armed. This feature also allows the user to leave the armed premises without having to disarm and rearm the system. Note For UL Listed systems, Quick Exit must be turned off. When this feature is on, pressing D on a touchpad (while the system is armed) starts a 2-minute timer that allows one standard entry or exit door (sensor groups 10 and 19 only) to be activated once (opened, then closed).When this feature is turned off, the system must be disarmed before opening any protected door. ¾ To turn Quick Exit off or on: 1. With the display showing QUICK EXIT OFF/ ON (current setting), press 1 (off) or 2 (on). The display flashes the entered setting. 2. Press ƒ and the display shows the new setting. Exit Extension (0013) Security-Partition 1 (Default = on) This setting determines whether or not the user can reenter and exit again ¾ To turn Exit Extension off or on: through an entry or exit delay door (without disarming and rearming the sys- 1. With the display showing EXIT EXTENSION tem). This helps prevent exit faults and false alarms by allowing users to OFF/ON (current setting), press 1 (off) or 2 reenter the armed premises for a forgotten item. (on). The display flashes the entered setting. When Exit Extension is on, the panel restarts the exit delay timer if the user 2. Press ƒ and the display shows the new set- reenters the premises through a designated delay door before the exit delay ting. time expires. When Exit Extension is off, the exit delay timer does not restart if the user reenters the premises. This forces the user to disarm the system to avoid setting off an alarm. Auto Stay Arming (0014) Security-Partition 1 (Default = on) This setting determines whether or not the system automatically arms to STAY (level 2) if the user arms the system to AWAY (level 3) without exiting the premises. This can help prevent accidental alarms by deactivating interior motion sensors during occupied arming periods. Note Arming the system to AWAY with No Delay overrides the Auto Stay Arming feature. With the feature turned on, the user arms the system to AWAY. Touchpads (and other status sounders) emit one exit delay beep every four seconds, then one every second during the last 10 seconds. If the exit delay time expires with no standard delay sensor activation, the system automatically arms to STAY. ¾ To turn Auto Stay Arming off or on: 1. With the display showing AUTO STAY ARMING OFF/ON (current setting), press 1 (off) or 2 (on). The display flashes the entered setting. 2. Press ƒ and the display shows the new setting. Programming the Panel 22