GE 60-806-95R-16Z Installation Instructions - Page 8

Note For UL 1635 installations, Entry Delay plus Dialer Abort Delay must not exceed 60 seconds. Note For 24-hour backup, external power drain is limited to 90 mA continuous using a 4.0AH battery. Planning the Installation Function Cancel Report Annunciation Operation Enabled UL 1635 Digital Alarm Communicator System Same as UL 1023 & 985 plus: • AC FAILURE set to on • PHONE NUMBER must be programmed • HIGH LEVEL REPORTS set to on. • LOW LEVEL REPORTS set to on • PHONE TEST set to on • AUTO PHONE TEST set to on • PHONE TEST FREQ. set to 1 • NEXT PHONE TEST set to 1 • LOW CPU BATTERY set to on • COMM FAILURE set to on • RF TX TIMEOUT set to 4 hours Central Station Reporting The panel has been tested with the following central station receivers using SIA and Contact ID reporting formats: • ITI CS-5000 Central Station Receiver • Sur-Gard Central Station Receiver with models SG-DRL2A and SG-CPM2 UL-Canada Listed Systems This section describes the requirements for ULC (UL Canada) Listed systems. • CSA Certified Accessories The UL-Canada Basic System is nearly the same as the "UL Basic System" described previously, the only difference being that you must use the ITI 60-679-CN Class II transformer (Basler part number BE 116250-AAA) to power the panel. • Residential Burglary Alarm System Unit (CAN/ULC-S309) Same as "UL Basic System and Household Burglary Alarm System Unit (UL 1023)" described previously and siren timeout must be set to 5 minutes or more. Residential Fire Warning System Control Unit (CAN/ULC-S545-M89) Same as "UL Basic System and Household Fire Warning System (UL 985)" described previously. California State Fire Marshall Listed Systems Same as Household Fire Warning System (UL 985), plus: • SMOKE VERIFY must be set to off This section describes the system capabilities to help you get familiar with the system. To help you prepare for system installation, Appendix A provides planning sheets with tables that let you record the hardware and programming configuration of the system. Standard Panel The following describes the basic panel (out-of-box) hardware capabilities. • Power: Input for an AC step-down, plug-in style transformer. • Auxiliary Power Output: Output that supplies up to 750 mA (90 mA for UL Listed systems) at 12 VDC for bus devices and hardwired detectors, such as touchpads and motion detectors. 3 Planning the Installation