HP 1300 Service Manual - Page 164
Cold reset, To perform a cold reset
UPC - 808736419819
View all HP 1300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 164 highlights
Note Note Cold reset A cold reset changes most system parameters in NVRAM to the factory defaults. However, unlike NVRAM inititialization, a cold reset does not reset the page count, the paper tray sizes, language, or formatter number. If an HP Jetdirect card is installed, remove it before performing a cold reset. Otherwise, the procedure will also reset all the HP Jetdirect settings as well as the printer settings. To perform a cold reset 1 Turn the printer off. 2 Press and hold down the GO button. 3 Turn the printer on, and continue to hold the GO button for at least 5 seconds, but not longer than 15 seconds. During this process, the Attention LED will turn on. 4 Release the GO button. If both the Attention and the Ready LEDs turn on before you release the GO button, you must start the procedure again with step 1. 5 The printer's LEDs will begin cycling. The cold-reset process will run until completion, and the printer will return to the ready state. 164 Chapter 6 - Troubleshooting ENWW