HP 5100tn Printer Job Language - Technical Reference Manual - Page 253
HP LaserJet 5Si, Mopier Comments
View all HP 5100tn manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 253 highlights
HP LaserJet 5Si Mopier Comments PJL commands are used to specify the destination bin and control printer functions such as stapling and collating multiple copies. Specifying the Output Bin Documents are sent to specific output bins using the @PJL SET OUTBIN command. The HP LaserJet 5Si Mopier bin definitions are as follows: Bin Description OUTBIN Variable Name Engine face-down bin UPPER High Capacity Output (HCO) OPTIONALOUTBIN1 face-up bin Stapling bin (in mailbox mode) OPTIONALOUTBIN7 Stapling bin (in stacker or job- OPTIONALOUTBIN3 separator modes) First non-stapling bin in mail- OPTIONALOUTBIN2 box mode (only bin in stacker and job-separator modes) Last non-stapling bin (bottom OPTIONALOUTBIN6 bin in mailbox mode) Stapling Documents To staple a document, include the following PJL command in the PJL header at the beginning of the job (see the example on the following page): @PJL SET FINISH=STAPLE To staple the output using this command, the printer automatically determines which bin is the stapling bin, so the output bin does not need to be specified using the @PJL SET OUTBIN command. The printer uses the EOJ command to determine the end of job so that the job can be stapled correctly. Note Future printers may enable stapling using a different command sequence. Feature Support A-41