HP 5100tn Printer Job Language - Technical Reference Manual - Page 85

PCL-Specific Variables The following variables are PCL-specific and can be set and requested using PJL. These variables must be set using the LPARM : PCL option. A sample value range is shown in this table. See Appendix A for the actual value range for each PJL printer, or use the INFO VARIABLES command to request these values from the printer. Note These variables are listed in alphabetical order, not the order they are used. The recommended order for setting FONTNUMBER, FONTSOURCE, and SYMSET is SYMSET first, then FONTSOURCE, then FONTNUMBER. PCL-Specific Variables Variables Description Sample Value Range FONTNUMBER Font number. The valid range for this variable depends on the currently set font source. If the font source contains a default-marked font, the values start at 0; otherwise, the values start at 1. The upper limit depends on the number of installed fonts in the font source. For example, if there are 50 fonts in the font source and there is a default-marked font, the FONTNUMBER values range from 0 to 49. In the same situation without a default-marked font, the values range from 1 to 50. 0, 1, 2, . . . n (continued on the following page) Environment Commands 6-23