HP 9000 rp4410-4 Installation Guide, Sixth Edition - HP 9000 rp4410/rp4440 - Page 88
Powering Off the Server, Step 2., Powering Off the Server Using the iLO MP PC Command
View all HP 9000 rp4410-4 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 88 highlights
Installing the System Powering ON and Powering OFF Step 2. Press the power button to start the server. Step 3. Start the operating system. Powering Off the Server Power off the server using the following methods if the server is in the standby or full power state: • iLO MP PC command • Power button Powering Off the Server Using the iLO MP PC Command To power off the server using the iLO MP PC command, follow these steps: Step 1. Gracefully shut down the operating system. Step 2. Initiate a console session, and access the MP Main Menu. Step 3. Enter CM to enable command mode. Step 4. Enter PC to use the remote power control command. Step 5. Enter OFF to power off the server, and enter YES when prompted to confirm the action. CAUTION The main dc voltage is now removed from the system; however, ac voltage for standby power is still present in the server. Step 6. Unplug all power cables from the receptacles on the rear panel of the server. Powering Off the Server Manually To manually power off the server, follow these steps: Step 1. Gracefully shut down the operating system. Step 2. Press the power button to power off the server. CAUTION The main dc voltage is now removed from the system; however, ac voltage for standby power is still present in the server. Step 3. Unplug all power cables from the receptacles on the rear panel of the server. 88 Chapter 1