HP EliteDesk 800 Maintenance and Service Guide - HP EliteDesk 800 G1 Tower, HP - Page 118
expansion socket on the system board 2.
View all HP EliteDesk 800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 118 highlights
8. If you are not installing a new expansion card, install an expansion slot cover to close the open slot. CAUTION: After removing an expansion card, you must replace it with a new card or expansion slot cover for proper cooling of internal components during operation. 9. To install a new expansion card, hold the card just above the expansion socket on the system board then move the card toward the rear of the chassis (1) so that the bracket on the card is aligned with the open slot on the rear of the chassis. Press the card straight down into the expansion socket on the system board (2). NOTE: When installing an expansion card, press firmly on the card so that the whole connector seats properly in the expansion card slot. 10. Rotate the slot cover retention latch back in place to secure the expansion card. 106 Chapter 6 Removal and replacement procedures: Small Form Factor (SFF)