HP EliteDesk 800 Maintenance and Service Guide - HP EliteDesk 800 G1 Tower, HP - Page 169
Heat sink, Heat sink retaining screws should be removed in diagonally opposite pairs as in an
View all HP EliteDesk 800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 169 highlights
Heat sink Description Heat sink Spare part number 587456-001 The heat sink is secured by four Torx screws. It does not have an attached fan. 1. Prepare the computer for disassembly (Preparation for disassembly on page 141). 2. Remove the access panel (Access panel on page 142). 3. Lift the front fan up and place it on top of the optical drive to access the front bezel release tabs. You do not need to disconnect the fan cable from the system board. 4. Loosen the four Torx T15 screws that secure the heat sink to the system board, and then lift the heat sink from the system board. CAUTION: Heat sink retaining screws should be removed in diagonally opposite pairs (as in an X) to even the downward forces on the processor to avoid damage that could require replacing the system board. 5. Lay the heat sink on its top in a safe area to prevent the thermal grease from contaminating the work surface. If reusing the existing heat sink go to step 1. Heat sink 157