HP EliteDesk 800 Maintenance and Service Guide - HP EliteDesk 800 G1 Tower, HP - Page 138
Refer to the following image for the location of the slots on the back of the chassis in which to install
View all HP EliteDesk 800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 138 highlights
3. From the outside, rear side of the chassis, remove the silver security screw that secures the solenoid lock to the chassis. 4. From the inside of the chassis, disconnect the cable (1) from the system board connector labeled HLOCK. 5. Remove the solenoid lock from the chassis (2). To install the solenoid lock, reverse the removal procedure. Refer to the following image for the location of the slots on the back of the chassis in which to install the solenoid lock. When installing, insert the top tabs into the top slots, and then rotate the lock downward. Then install the security screw on the outside of the computer. Plug the connector into the system board connector. 126 Chapter 6 Removal and replacement procedures: Small Form Factor (SFF)