HP LH4r HP Netserver LPr Installation Guide - Page 29
Replace
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
Chapter 3 Opening and Closing the HP NetServer LPr Replace 1. When replacing the top cover, make sure that all cables and the system board ejector levers are out of the way. 2. Align the front lip of the top cover so it will slide under the front panel edge. 3. Push the top cover forward and down until all edges are evenly aligned on the enclosure. 4. Turn the thumbscrews at the rear of the enclosure clockwise to tighten. Figure 3-5. Replacing the Top Cover 21
Chapter 3
Opening and Closing the HP NetServer LPr
21
Replace
1.
When replacing the top cover, make sure that all cables and the system
board ejector levers are out of the way.
2.
Align the front lip of the top cover so it will slide under the front panel
edge.
3.
Push the top cover forward and down until all edges are evenly aligned on
the enclosure.
4.
Turn the thumbscrews at the rear of the enclosure clockwise to tighten.
Figure 3-5. Replacing the Top Cover