HP LH4r HP Netserver LPr Installation Guide - Page 54
Removing PCI Cards, Installing a Remote Control Card
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 54 highlights
Chapter 7 Installing Additional Boards Removing PCI Cards Apply the same steps as in the installing procedure and simply remove the PCI card and the PCI retaining bracket. Replace the slot cover. See the preceding section for details. Installing a Remote Control Card Refer to the Top Tools Administration Guide for Remote Control along with the upgrade kit documentation for information on the remote control card. 1. Connect the four-pin ribbon cable (shipped with the remote control card) to the remote control card. Refer to the upgrade kit instructions. 2. Route the cable through open spaces in the chassis to the I/O board. 3. Connect the cable to the IPMI/I2C connector on the I/O board. Figure 7-6. IPMI/I 2C Connector to Remote Control Card 46