HP LH4r HP Netserver LPr Installation Guide - Page 81
Step 9, Fasten the brackets to the rear columns.
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 81 highlights
Chapter 9 Mounting the Server in the Rack Step 9: Fasten the brackets to the rear columns. NOTE The brackets serve to dampen vibration of the server chassis. • Line up the screws as shown below. The bracket should be in contact with the foot protruding from the rear of the LPr chassis. • Finger-tighten four T25 Torx screws, two in each rear column, through the flanges into the rack nuts. Figure 9-13. Finger-Tighten the Brackets to the Rear Columns 73
Chapter 9
Mounting the Server in the Rack
73
Step 9:
Fasten the brackets to the rear columns.
NOTE
The brackets serve to dampen vibration of the server chassis.
•
Line up the screws as shown below. The bracket should be in contact
with the foot protruding from the rear of the LPr chassis.
•
Finger-tighten four T25 Torx screws, two in each rear column,
through the flanges into the rack nuts.
Figure 9-13. Finger-Tighten the Brackets to the Rear Columns