HP LH4r HP Netserver LPr Installation Guide - Page 42
Removing DIMMs
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
Chapter 5 Installing Additional Memory DIMM Notches Keys Retaining Clips Figure 5-3. Inserting a DIMM into a Connector 8. Repeat step 2 to install all of the DIMMs for your memory configuration. 9. If you are not installing any other options, replace the top cover. See Chapter 3, "Opening and Closing the HP NetServer LPr." NOTE Most DIMMs are dimensionally identical, so if you have three or more DIMMs installed, you may check that they are all seated by sliding a straight edge (a pen for example) across their top edges and checking that it remains in continuous contact with all of the DIMMs. Removing DIMMs You may need to remove a DIMM module to downsize your memory configuration or to replace a defective DIMM. 1. Log off all users. Back up files. Follow instructions in your network operating system (NOS) documentation to gracefully shut down all networking software and applications. 2. Press the power switch on the HP NetServer's control panel when prompted by the operating system. 3. Disconnect the power cables and signal cables and, if necessary, label them to support reassembly. 34