HP LH4r HP Netserver LPr Installation Guide - Page 34
Installing Hot-Swap Drives
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 34 highlights
Chapter 4 Installing Mass Storage Devices Configuring the SCSI Host Adapter In order to verify or modify SCSI host adapter settings, or to low-level format SCSI disks or verify SCSI media, run the Symbios Configuration Utility. See Chapter 11, "Configuring the NetServer LPr," for further information. Installing Hot-Swap Drives CAUTION Protect the drive from static electricity by leaving it in its anti-static bag until you are ready to install it. Before handling the drive, touch any unpainted metal surface to discharge static electricity. When you remove the drive from the anti-static bag, handle it only by the frame . Do not touch the electrical components. Place the drive on the anti-static bag whenever you set it down. Hard disk drives are very susceptible to mechanical shock and can be damaged by a drop as short as one-quarter of an inch. Take care when unpacking and handling the drive. If the drop would crack an egg, it will damage the drive. 26