HP LH4r HP Netserver LPr Installation Guide - Page 33
Hot-Swap Drive Bay Addresses, Other SCSI Device Addresses
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
Chapter 4 Installing Mass Storage Devices Hot-Swap Drive Bay Addresses The hot-swap bays are addressed from left to right as 0 and 1. The system will default to booting from the drive with SCSI ID 0 on the left bay. SCSI ID 1 Figure 4-1. Hot-Swap Bays SCSI ID 0 Other SCSI Device Addresses Other SCSI devices connected to LPr's embedded SCSI channel can never use device ID 7 (the embedded SCSI controller). Other SCSI devices can use device IDs 0 and 1 if those hot-swap bays are not in use. 25
Chapter 4
Installing Mass Storage Devices
25
Hot-Swap Drive Bay Addresses
The hot-swap bays are addressed from left to right as 0 and 1. The system will
default to booting from the drive with SCSI ID 0 on the left bay.
SCSI ID 0
SCSI ID 1
Figure 4-1. Hot-Swap Bays
Other SCSI Device Addresses
Other SCSI devices connected to LPr’s embedded SCSI channel can never use
device ID 7 (the embedded SCSI controller). Other SCSI devices can use device
IDs 0 and 1 if those hot-swap bays are not in use.